|
|
Post by Robin on Feb 22, 2005 9:40:58 GMT -5
How do I change the brightness on my Stentura 8000 display? It is so dark, I cannot read it. I thought there was a mode where I could change the brightness, but am I wrong?
|
|
|
|
Post by Michael Smith on Feb 22, 2005 18:40:05 GMT -5
Hello Robin,
Holding your writer in front of you as if you were writing, look on the rear of the machine on the left-hand side. You should see a knob (sort of a flat-head screw driver look). Turn this knob in very very small increments to adjust the brightness of your display.
Best Regards,
|
|
