|
|
Post by Cynthia on Jul 14, 2005 4:46:11 GMT -5
The LCD display on my Sten. 6000+ is almost not visible. I can see it very faintly from an angle. Help!
|
|
|
|
Post by Michael Smith on Jul 14, 2005 18:18:43 GMT -5
Hello Cynthia,
It sounds like your contrast knob is out of adjustment. If you look on the rear of your Stentura, left side you should see either one or two knobs (depending on when your writer was manufacturered). If you see two knobs, VERY SLOWLY turn the outside knob until the display is visible again. You MUST make very small adjustments. If you only see one knob, simply turn the one knob (again, very slowly).
Hope that helps!
|
|
